Hi folks.

I'm replacing the 110VAC 15 Amp shore power circuit breaker in a 1981
Canadian model Westfalia.

In that 110VAC breaker box, from the "factory", was the shore power
ground wire bonded to the Loomex ground wire to outlet and that
"single" wire was bonded to a single ground screw in the breaker box?
Did this also apply to US models?

On my van, it appears this was the case but was altered so the shore
power ground bonded to one screw on box and the outlet ground bonded
to another screw on that box.

Should I re do the ground like this:

bond a new #14 solid copper pig tail wire to ground screw in breaker
box, use marrette to connect the stranded green shore power ground,
and ground to outlet box, to that pig tail wire?

As far as I know, this is how a ground wiring to/from an outlet box in
a residence is done in Canada.

Thanks,

Neil.

-- 
Neil n

VE7TBN

1988 Westy 50º ABA swap: https://tinyurl.com/yap5hpwt

1981 Westy 15º ABA swap: https://tinyurl.com/y9n4xob8

VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>