my plan is to go to the junkyard and get a pair of rear shoulder belts
to install in my '87 syncro gl 7-pass.  apparently, there is a factory
threaded hole in the wall of my van ready to accept the belt wheel.  i
pulled off the plastic piece in the back that runs from the floor to the
ac housing, but i don't see a hole.  i can feel one through the vinyl, i
think, but i'm hesitant to tear the vinyl unessecarily.  am i doing the
right thing?  goesty has a picture of the installed belt, so i'm fairly
sure i'm poking in the right place.  has anyone done this operation?

thanks y'all!

aaron
'87 syncro gl