I had gotten conflicting answers to my question that i posted earlier
so i am posting it again... just to make sure i have the right info..
I have to convert my new engine from a manual trans setup to an auto
trans setup... questions were.. do i have to remove the little guide
bearing in the end of the crank that is there
for the manual trans? i got a reply that the torque converter will not
seat properly if it is not pulled out.. and second.. is.. do i still
have to set the end play even though i am not using a clutch? I am
fairly sure that i do.. but just want to make sure... also.. if anyone
is in need of a new flywheel P-mail me with an offer...
thanks everyone,
jesse
89 carat