Regards

Please take a look at a specific picture on my web site (in construction)

http://www3.sympatico.ca/huotx/oil_pressure_sender_overview.htm

I would need confirmation on the color/wiring/connector for the .9 BAR rear
oil sender.

Mine was (Previous owner) cut near the sender (I think it was cut by the
belt) and it was so difficult to reach that the PO grounded the wire to the
engine, this way the signal to the oil light look OK. (close). (I hope�..
oil pressure was taken by my friend last year and was OK, but I was not
there to see!!!)

If you could check your van and confirm that the 2 brown wire that come
from the same connector (see picture) goes to each sender.

By Bentley 97.108, it confirms what I am thinking. I would like a physical
confirmation from one of you guys.

If not, can you tell me where the .9 rear sender brown wire goes?

Best regards, Ben

87GL
http://pages.infinit.net/eurokit/