

| Subject: | Re: Temp & Fuel gauges not accurate |
| From: | John P. Flaherty |
| Date: | Sat, 29 Sep 2001 19:35:55 -0400 |
There's a little voltage regulater for the guages. Costs like 3 bucks + shiping from list vendors. Fixed my guage problem. HTH, John Flaherty Portland, ME ----- Original Message ----- From: "Andrew M Fox" <andrewf@HAWAII.EDU> To: <vanagon@GERRY.VANAGON.COM> Sent: Wednesday, September 26, 2001 11:45 PM Subject: Re: Temp & Fuel gauges not accurate > You can check the operation of the sending units for fuel and temp by > checkin the resistance, measured in ohms with a voltmeter. The values for > the temp gauge are below. The values for the gas gauge are on gerry > somewhere in the technical section. If the senders are working properly > you can check the gauges by buying some resitors from radio shack and > "faking" the signal to the gagues. Good luck and here is the temp sensor > data: > 32 F 5,000-6,500 Ohms > 68 F 2,000-3,000 Ohms > 104F 1,000-1,500 Ohms > 140F 500-675 Ohms > 176F 275-375 Ohms > 212F 150-250 Ohms > > Andrew Fox > www2.hawaii.edu/~andrewf/vanagon/links.htm > > > On Wed, 26 Sep 2001, Hans Roos wrote: > > > I've got an 89 Syncro and the fuel and temp gauges both work but they do > > not give accurate readings. I have already checked & replaced the voltage > > regulator for the gauges but that made no difference. Here is what is > > occurring: > > > > Fuel Gauge - Fill the tank and it reads full, as I drive it falls very > > quickly, after about 100 miles (which takes about 1/2 a tank) it reads dead > > empty, filling it up starts the process all over again. When the problem > > first started it was only intermittent - now it happens all of the time. > > > > Temp Gauge - It simply reads to low. It used to read just fine but now it > > barely gets off of the bottom white square. I know the temps are higher > > than this as the cooling fan kicks in. I have replaced the sender - no > > change :-( > > > > I do not think the inaccuracy of the gauges is caused by the same problem > > as the problems started happening many months apart but I've been wrong > > before! Any suggestions or ideas? > > > > -Hans > > >
Have something to add on this topic today? Revive this thread in the forum »