I spent Saturday afternoon replacing fuel lines with the Ken Wilford Kit I
bought 6-8 months ago. I also decided to take Kens advice and pull the
injectors and clean them up (wire brush off the rust and repaint). THe
rubber around the injectors seemed pretty good. I tried to be careful and
put the same wires on the same injectors. Van runs pretty well but I needed
to adjust the idle down afterward. Okay, the questions: 1. I just popped the
injectors back in. Should I have used some sort of silicone sealer?  2. What
id I mixed up the wires. How would the van run? How would the injector know
when to inject? Does it know some way? Did I just get lucky and put them on
right? (I am not usually that Lucky).
Just curious.

Jonathan R. Cooper
Brzytwa, Quick & McCrystal
900 Skylight Office Tower
Cleveland, OH 44113
Cooper@BQMlaw.com