

| Subject: | Re: Drive shaft installation |
| From: | EMZ |
| Date: | Fri, 31 Dec 1999 12:04:52 -0500 |
Its the shaft, or the front diff. Run the van without the drive
shaft. If it goes away completely, its the drive shaft. If it is
still there, but at a different speed, start looking at the diff.
This is the reason VW states these are not rebuildable. No one
can figure this out...
Eric 86-VW4x4
vw4x4@fyi.net 72-240z
Pittsburgh, PA USA 1936-Chrysler
On Fri, 31 Dec 1999, Shortlidge D Joel wrote:
> I just tried to reinstall my drive shaft after having the u-joints
> replaced and balanced! But I got a vibration at 35 mph! I did not
> loosen the front diff bolts is this the reason or is the shaft out of
> balance???
>
> Joel
>
>
> On Sun, 26 Dec 1999 15:33:29 -0500 (EST) EMZ <vw4x4@fyi.net> writes:
> > Hi joel,
> > If you did not remove the trans. or the front dif. and did not
> >change the drive shaft in any way, I fonud that loosening the front
> >dif. mounts are a waste of time. The alignment of the drive shaft
> >will end up unchanged. But if any of the above has changed you need
> >to lossen up (alot), all 3 mounts to the front dif. in order to get
> >it to move, and be adjustable.
> >
> > Eric 86-VW4x4
> > vw4x4@fyi.net 72-240z
> > Pittsburgh, PA USA 1936-Chrysler
> >
> >
> >On Sun, 26 Dec 1999, Shortlidge D Joel wrote:
> >
> >> Hey, Syncro owners that have replaced there shaft them
> >selves. Do you
> >> have to loosen ALL the front diff mount bolts to realign the shaft.
> >Or
> >> can you get away with just loosening the rear two??
> >> Please e-mail me anyone on the list if you get this message!
> > I am not
> >> on the list so direct e-mail me, I don't know if the e-mail are
> >getting
> >> through, Thanks.
> >>
> >> Joel
> >> ________________________________________________________________
> >> YOU'RE PAYING TOO MUCH FOR THE INTERNET!
> >> Juno now offers FREE Internet Access!
> >> Try it today - there's no risk! For your FREE software, visit:
> >> http://dl.www.juno.com/get/tagj.
> >>
> >
>Have something to add on this topic today? Revive this thread in the forum »