

| Subject: | Re: Rear hatch |
| From: | OlRivrRat |
| Date: | Tue, 21 Sep 2021 22:19:50 -0600 |
My guess would be that on Hatches with Window Wipers, the Wiper Motor may add more weight to 1 side ~ > On 21 Sep , 2021, at 6:16 PM, David McNeely <davmcneely40@GMAIL.COM> wrote: > > I replaced the struts soon after I got the van in 2008. The old ones had > just gotten tired, and would not hold the hatch up. I just got whatever > was available at some place like NAPA. They came left and right. I could > not tell one from the other, so I asked. The answer I got was that no one > really knew, but that if I put them wrong, the hatch could tell! I later > learned that it was that one was more resistant than the other, but at the > time I still didn't understand the reason. Maybe I still don't. If the > originals were too strong, why not make both sides just a tad weaker rather > than one side more so? Also, why would it matter which side was stronger? > Or maybe, and I just don't remember this, do they have different fasteners > on the two sides, Dennis? Still going strong on those 13 yo FLAPS struts. > mcneely > > On Tue, Sep 21, 2021 at 2:06 PM Dennis Haynes <d23haynes57@hotmail.com> > wrote: > >> At some point the factory supplied different struts for each side with the >> combined operation being to hold the hatch in most any position. Some folks >> can't reac it whe all the way up and also full extension is a problem in >> some garages. As for them failing frequently they don’t like winter, fast >> operation, slamming into the end stops, and being touched or pulled from >> the side. Personally, I miss the old reliable torsion springs used on the >> bay window hatches. >> >> Dennis >> >> >> -----Original Message----- >> From: Vanagon Mailing List <vanagon@gerry.vanagon.com> On Behalf Of Dan >> Lamb >> Sent: Tuesday, September 21, 2021 2:51 PM >> To: vanagon@GERRY.VANAGON.COM >> Subject: Re: Rear hatch >> >> It sounds like the hinges are still binding. Might try loosening hinge >> bolts slightly either at the door jamb or on the door itself and see if a >> very small nudge will allow the hinges to move more freely. Also check the >> gap all around. Could be it got dropped or pushed down hard with something >> in a corner that left it with a slight warp or twist. If you see a >> difference, put a 2x4 in the opposite corner and push down gently to try to >> straighten it. >> Could remove the struts and rule them out as part of the problem. Yeah, >> door is heavy. Maybe get someone to help. Good luck. At least it works. >> Haha Dan Country Homes Camper, the Huckleberry Sky >> >>> On Sep 21, 2021, at 1:31 PM, Eric Caron <ericcaron96@comcast.net> wrote: >>> >>> Hi Dan, >>> >>> I recommend trying new struts. You can always have a spare ready if >> that isn’t it. >>> >>> Or, try struts from one of your other vans and see if it is healthy >> again. >>> >>> Eric Caron >>> 85 GL Auto >>> Changed struts from GW in 2014 and still good. >>> >>> >>> >>>> On Sep 21, 2021, at 2:23 PM, Dan N <dn92610@GMAIL.COM> wrote: >>>> >>>> Thank you all. >>>> >>>> I will try some struts combinations. >>>> >>>> The thing is ... the hatch does not go down if I stop pushing it, it >>>> stays, so I am safe here. It doesn't go up as easily as on my other >>>> vans and pulling it to close requires as much effort to push it to open. >>>> >>>>> On Tue, Sep 21, 2021 at 11:14 AM David Beierl <dbeierl@gmail.com> >> wrote: >>>>> >>>>>> On Tue, Sep 21, 2021 at 2:11 PM Gil Ngai <gil@dayonemedia.ca> wrote: >>>>> >>>>>> How do you tell which are the strong struts when buying them? >>>>>> Do you know where to get them? >>>>>> >>>>> >>>>> If I once knew which was which I've forgotten. But Bus Depot can >>>>> tell you I'm pretty sure. >>>>> >>>>> Yrs, >>>>> d >>>>> >>
Have something to add on this topic today? Revive this thread in the forum »