Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Syncro starter removal
From:Scott Daniel - Turbovans
Date:Wed, 22 Dec 2010 20:00:21 -0800

I wouldn't  consider owning or operating a van without a 'starter trigger'
wire hidden in the engine compartment somewhere, so there's an alternative
method to operate the starter.
  Could really save your butt sometime,
and we know the stock circuit with somewhat underbuilt ignition switch is
weak anyway ..
and now all the wires and connectors are 25 + years old.

Plus, a wire added in like this is very handy for diagnosing starter
problems.

Scott
www.turbovans.com
----- Original Message -----
From: "Richard Jones" <jones@COLORADO.EDU>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Wednesday, December 22, 2010 7:02 PM
Subject: Re: Syncro starter removal

> Alistair wrote:
>> Also make sure the
>> spade connector from ign to solenoid is on there good and tight. If I
>> had the chance, i'd replace that terminal with a screw on connection.
>> I found it most vexing when it came adrift on a trip this last
>> summer, very awkward to re-attach on the road.
>
> Syncro bro Bob and I strongly agree with this.  We spent over an
> hour under his van in Maybell, Colorado--"conveniently located in the
> middle of nowhere"--working to get his reattached.  Four hands and
> a table knife and a pair of vice grips finally did it.
>
> Richard