Good Afternoon,

I am preparing to repack and replace the boots on the outer CV joints on
the front axles of a 1987 Syncro.  I'd like to find out from anyone
who's done this messy little task if, once you have detached the axles
from the front differential is there enough clearance to slide the axles
out of the front hub assemblies without further disassembly of the front
end.

As a note,  I've done several rear axle CV builds,  but any additional
pointers on the Vanagon front  axles is appreciated.
--

*Best Regards,
Jon B Kanas
Email: kanas@qadas.com <mailto:kanas@qadas.com>
LinkedIn: http://www.linkedin.com/in/jonkanas
Longmont, Colorado; Cultural Center of the Universe
Website: http://www.qadas.com/~kanas <http://www.qadas.com/%7Ekanas>
AOL Instant Messenger ID: KanasColo
*