In a message dated 29/11/2005 12:05:46 A.M. Eastern Standard Time,
LISTSERV@GERRY.VANAGON.COM writes:

Did you  do the job with the cabinet in the van? Was the cut-out done
with a  jigsaw?

All modifications were was done with the cabinet in  place.  75% of the cut
was done with a jig saw with two layers of masking  tape on the surface.  That
top edge was the bugger.  I used a fine  tooth hand saw as there is no room
for the jig saw up there.  A sawsall  would have worked but I had no sawsall
available.

Cheers,

Frank  Condelli
Almonte, Ontario, Canada
'87 Westy, '90 Carat, '87 Wolfsburg  (Forsale) & Lionel Trains
Vanagon/Vanagon Westfalia Service in the Ottawa  Valley
_Frank Condelli  & Associates_ (http://members.aol.com/Fkc43/busindex.html)
_Vanagon Stainless Steel Exhaust  Systems_
(http://members.aol.com/Fkc43/stebro.htm)
_BusFusion_ (http://members.aol.com/BusFusion/bfhome.htm)  a VW Camper
camping event, Almonte, ON, June 08 ~ 11,  2006