Hi all
finally decided to take the plung and build up my 1st water box. have plenty of type 1 builds under my belt but not in the know on the 1.9L little things. so here
are a few of my 1st (probably in a series of) Question

1) are the type 1 and 1.9L rod bearings the same?? or are they the same as type 4? or 1.9L special? ( to me they look like type 1)
2) if i have a rod Journal size of 2.145 am i going to need a .25mm or .50mm bearing for that rod??
3) what is the best way to clean the case? Dishwasher? (in my single days maybe, but now i choose life), solvent tank that i have, hose and water, or steam
clean professional or and lastley chemical dip?

Btw the crank, rods, pistons, flywheel and any thing else that moves have been fully balanced by a professional engine builder. rods rebushed and sized. crank
polished, flywheel ground.

thanks for your help Jonce

Jonce Fancher

57 Single Cab
66 Sunroof Bug
66 Variant Squareback
71 Sunroof Bus
75 911S Sunroof
84 Vanagon "Godfried"
85 Vanagon Westi
2003 10 Passenger Sprinter

Fancher's Upholstery Inc. -  www.fanchers.com
Not-A-VW Club- http://mywebpages.comcast.net/jaransont3/notavwclub/