Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Brake Bleeding
From:Michael Knight
Date:Thu, 30 Dec 2004 15:46:00 -0600

>From: "Joel Walker" the rule of thumb is to bleed from the fartherest away
>from the brake fluid reservoir, to the next-fartherest, and so forth.

>so on a vanagon, you'd start with the right rear, then the clutch slave
>cylinder (if you have a manual transmission), then the left rear, then
>right front, and lastly, the left front. like that.

>p.s. i've had really good luck using a Mity-Vac from wal-mart. it sucks the
>old fluid out at each wheel. kinda 'exercises' your hands, though. ;)  and
>you have to get up after each wheel and go refill the reservoir.

So the Slave cyllinder must be bled as weel while doing the brakes. That one
I did not do. I will try again tonight.

But my clutch feels fine the brakes are squishy until i give them a pump or
two. I did replace the slave cylinder last week.

I knew that Mity-Vac had another purpose. I will pull it out and knock the
dust off of it. I usually use the 2 man method/man and a good stick method
to bleed the brakes.

Thanks,

Michael Knight
'77 Westy Deluxe, "el Verde"
'85 Vanagon GL, nameless