| Subject: | Correction Re: Selector shaft seal questions / conformation |
| From: | Alistair Bell <albell@SHAW.CA> |
| Date: | Sun, 13 Jun 2021 19:03:42 -0700 |
Correction… I’m just replacing the seal, not the shaft
And I meant confirmation, not conformation
Alistair
> On Jun 13, 2021, at 6:06 PM, Alistair Bell <albell@shaw.ca> wrote:
>
> My seal leaking badly, one of the reasons I dropped tranny ( clean up etc easier)
>
> Selector shaft replacement, need confirm
>
> Select neutral
> Remove shift shaft cover from drivers side
> Tap shaft to cover side
> I guess remove and have a look
> Pull seal from other side
> Now…
>
> Should I insert seal into tranny and then push shaft back thru?
> Or
> Push shaft thru then insert seal
>
> I’m leaning to the latter , just because of less chance of damaging seal with shaft.
>
> Thanks
>
> Alistair
>
